Cabinet Refacing Claremore, OK
C&A Roofing & Construction refaces kitchen cabinets for homeowners in Claremore, OK and Rogers County. Refacing keeps your existing cabinet boxes and replaces every surface you see: doors, drawer fronts, and the face frame skin. It is the shortest path to a new-looking kitchen when the boxes are still solid, and it is a common first step for people planning kitchen remodeling in Claremore.
Cabinet Refacing vs. Cabinet Replacement
Refacing reuses the boxes. Replacement tears them out. The deciding factor is box condition, not looks. Open a door and push on the shelf. If the box is plywood, square, and dry, refacing gives you the same visible result as new cabinets in a fraction of the working days.
Replacement wins when the layout has to move, when you want deeper drawer banks in place of doors, or when the boxes are swollen at the toe kick. Refacing does not change the footprint. If you want a different layout or an added run of cabinets, that is a full kitchen project and belongs on the parent page. Dollar figures for either path live in our remodel cost guide.
What Cabinet Refacing Includes
We remove the old doors, drawer fronts, and hardware. Exposed face frames and cabinet ends get sanded, then covered with matching wood veneer or rigid thermofoil. New doors and drawer fronts go on with new hinges, and we add soft-close hardware, new pulls, and matching toe kick and crown where it runs. Interiors can get roll-out trays and shelf liner while the doors are off.
Drawer boxes are handled case by case. Solid boxes keep their slides or get undermount soft-close slides; stapled particleboard boxes get replaced. Refacing does not touch plumbing, tile, or your counters, so pair it with countertop installation only if the counters are also dated.
When Refacing Is Not the Right Call
Walk away from refacing when the boxes are failing. Sagging shelves, screws that spin in the stile, delaminated bottoms under the sink, or a dishwasher end panel that crumbles when you press it all mean the substrate is gone. New doors on a bad box fail at the hinge screws inside two years.
This is where Oklahoma humidity matters. Most builder-grade cabinets from the 1990s and 2000s around Claremore use particleboard boxes with a thin melamine skin. Particleboard wicks moisture, and our summer humidity plus a slow supply line leak under the sink swells the bottom panel until it will not hold a screw. Plywood boxes stay dimensionally stable through the same swings, which is why we check the sink base and the cabinet next to the dishwasher before we quote a reface at all.
Cabinet Refacing Timeline
Doors are made to order, so the calendar splits in two. Measuring and door ordering happen first, and fabrication typically runs three to five weeks. Nothing in your kitchen changes during that window, so you cook as usual.
On-site work is three to five days for a standard 25-door kitchen. Day one is removal, prep sanding, and veneer on the face frames. Day two is ends, panels, and toe kick. Day three is hanging doors, drawer fronts, and hardware, then adjusting every door for even reveals. Larger kitchens or added roll-outs add a day or two. A small kitchen remodel often finishes on the shorter end of that range.
Door Styles and Finishes We Install
Shaker is the volume seller: a five-piece door in maple or paint-grade poplar that suits both older Claremore homes and newer subdivisions. Slab doors in rift white oak or a matte thermofoil read modern. Raised panel and applied molding doors are still available in cherry and hickory when you are matching existing trim.
Finishes are factory-applied conversion varnish on wood doors, which holds up better over a range than anything sprayed on site. Painted doors come in white, greige, and deep navy or green for islands. Wood stains run from natural maple to a dark walnut. Any door style can be mixed, and we bring physical door samples to the estimate so you see the sheen in your own light.
Free In-Home Cabinet Refacing Estimate
We measure your kitchen, check the boxes, and bring door samples. No charge, no obligation.
Cabinet Refacing Claremore, OK FAQs
How long do refaced cabinets last?
Refaced cabinets last 15 to 20 years when the boxes are sound. The veneer is bonded to the face frame with contact adhesive and heat, and the new doors are the same solid wood or thermofoil doors used on new cabinets. Lifespan is set by the box underneath, not the new skin.
Can you reface cabinets and keep the same countertops?
Yes. Refacing never removes the boxes, so the countertop stays in place and the sink and plumbing are untouched. That is the main reason homeowners choose refacing when the counters are newer. Only the doors, drawer fronts, and exposed frame surfaces change.
Can you change the color of oak cabinets by refacing?
Yes, and it is the most common request we get in Rogers County. Golden oak frames get covered with a wood veneer or rigid thermofoil in the new color, and the doors are replaced outright. Oak grain does not telegraph through because the frame is skinned, not just painted.
Do you have to remove everything from the kitchen to reface cabinets?
Empty the cabinets that are getting new doors and clear the countertops near the work. The boxes stay attached to the wall, so dishes in upper cabinets on the far wall can usually stay put. We mask the room and run a dust containment fan during sanding.
Can you add soft-close hinges and drawer slides during refacing?
Yes. New hinges are installed with the new doors, so soft-close is standard on our refacing jobs. Existing drawer boxes can take undermount soft-close slides if the box is square and solid. Damaged or stapled particleboard drawer boxes get replaced with new dovetail boxes instead.
Cabinet refacing is one piece of kitchen remodeling in Claremore, and it fits alongside the rest of our home remodeling services. We build the reface around your schedule, order doors before we touch anything, and finish the on-site work in a few days. Payment plans are available through our financing options.